Paxar 9800 Series - Manual (Page 44)

5-16 Novell Network Configuration
3. Select the desired port (for example, LPT1:) under Ports: and the desired print
queue under Resources. If you have configured the XCD external print server
for NDS mode, you may alternatively select the printer name instead of the
print queue name.
4. Click Capture and Permanent.
5. Close the window and select Options and then Printer Setup.
6. Choose the desired printer under Installed Printers. If the desired printer
does not exist, select Add>> and select the printer from the List of Printers,
and click on Install (normally you will need either the original Windows diskette
distribution or the printer manufacturer's driver diskette).
7. If the desired printer is not on the correct port, click on Connect, select the
port, and click OK.
8. If desired, click Set as Default Printer to make the printer your default printer.
9. Exit the Print Manager.
T e s t i n g t h e P r i n t Q u e u e
Test the queue by printing a small job from an application program like the
Windows 95 Paint Accessory program (make sure that the program is set up to print
to the correct print queue if the print server is not assigned to service the default
queue). The file will be spooled to the print server for printing and should print on
the printer within a short period of time. If it does not, double check your
configuration, and if necessary, refer to the Troubleshooting chapter of this manual
for additional information.