Paxar 9800 Series - Manual (Page 47)

Windows NT/LAN/WARP Server Network Configuration 6-3
W i n d o w s N T V 4 . x x C o n f i g u r a t i o n
If you have Windows NT V3.5 or V3.51, skip to the next section.
1. Go to the Start button, choose Settings, and then select Printer. Double click
on the Add Printer icon to get the Add Printer Wizard. Select My Computer
(Not Network Printer) and click on Next.
2. Select Add Port, select LPR Port from the list of available ports, and click on
New Port.
3. Type in the IP address that you wish to assign to the print server in the Name
or address of server providing lpd: box. If you do not have a router on the
network, this IP address must match the first three bytes of the IP address of
your computer. For example, if your computer has an IP address of
192.189.207.53, your print server must have an address like 192.189.207.27.
4. Type in the print server service name (BINARY_P1) in the Name of printer of
print queue on that server: Click OK:
5. Click on Close. The new print server IP address should be listed and
highlighted as an available port. Click on Next.
6. Select the desired printer manufacturer and model (click Have Disk if your
printer is not listed), and click on Next.
7. If the driver already exists, select Keep Existing Driver (if it does not, this
step will be skipped), and then click on Next.
8. If desired, change the name of the printer and/or make it the default, and then
click on Next.
9. If desired, make the printer shared (so other users can access it), and select
the operating system(s) that these other computers will be running. Click on
Next.
10. Select Yes when you are asked "Would you like to print a test page?" Click on
Finish to complete the installation.
You may now print to the printer as if it were a local printer.
W i n d o w s N T V 3 . 5 x C o n f i g u r a t i o n
If you have Windows NT or NT AS V3.5 or V3.51, use the following procedure to
configure the XCD external print server: