Paxar 9800 Series - Manual (Page 38)

5-10 Novell Network Configuration
♦
Select Print Servers (NetWare 4.xx and later) or Queue Servers
(NetWare 2.xx and 3.xx), press Insert and enter the name of the print
server (the default print server names are discussed in the Default
Print Server Names section at the beginning of this manual).
♦ Go to Print Queues, select the desired print queue, then select Print
Servers and press Insert to select the name of the print server.
♦
Exit PCONSOLE.
4. Go back to XCONFIG and enter the command:
SET NETWARE RESCAN
After a few seconds, do a SHOW NETWARE command; you should see the
queue you created being serviced by the file server. You are now ready to
use the queue.
C o n f i g u r i n g t h e P r i n t S e r v e r a n d A d d i n g t h e P r i n t Q u e u e
i n R e m o t e P r i n t e r M o d e
To configure the print server for remote printer mode, there are two basic steps
required. First, you must use Novell's NWAdmin or PCONSOLE to add the print
queue to the NetWare server. Then you must configure the print server for remote
printer operation using XAdmin32, XAdmin, JetAdmin, WebXAdmin, or the print
server console.
C o n f i g u r i n g t h e P r i n t S e r v e r a n d P r i n t Q u e u e u s i n g
N W A D M I N a n d X A d m i n 3 2 , X A d m i n , W e b X A d m i n , o r
J e t A d m i n ( N D S R e m o t e P r i n t e r M o d e ) :
To configure the print server for remote printer mode with NWADMIN (NetWare
Administrator utility) and XAdmin32, XAdmin, WebXAdmin, or JetAdmin, perform
the following steps:
1. Make sure that the PSERVER NLM (NetWare Loadable Module) is loaded on
your file server and that you are logged in as ADMIN in NDS mode on the
NetWare 4.xx file server.
2. Start NWADMIN by double clicking on the icon. Select the desired Container
Object (Organizational Unit) that will contain the new printer.
3. Select Object from the menu bar and then Create. When you get the New
Object menu, select Printer and then OK.
4. Enter the name of the printer and select Create.