Paxar 9800 Series - Manual (Page 40)

5-12 Novell Network Configuration
♦
If you are using JetAdmin, one or more print server NetWare services
will show up in the list of printers (the default service names are
listed in the Default Print Server Names section at the beginning of
this chapter; note that JetAdmin supports a maximum of three ports
per print server). Single click on the one you want to configure, go to
the menu bar and select Device and then Modify. Then click Next
and select Operating Mode.
14. Select the Remote Printer as the Operating Mode, enter the name of your
PSERVER NLM as the Print Server Name, and select the number of the printer
from step 6 as the Printer Number (XAdmin32 and JetAdmin allow you to
choose from a list of available print server NLMs rather than typing in the
name).
15. If you have XAdmin 32 or XAdmin, click OK. If you have JetAdmin, click Next
two times, and then click Finish. If you have WebXAdmin, click Submit.
16. Exit the configuration utility. You must now unload the PSERVER NLM from
your NetWare file server console and then reload it in order for the changes to
take effect.
C o n f i g u r i n g t h e P r i n t S e r v e r a n d P r i n t Q u e u e u s i n g
P C O N S O L E a n d X C O N F I G ( R e m o t e P r i n t e r M o d e )
To configure the print server for remote printer mode operation using PCONSOLE
and XCONFIG, perform the following steps:
1. Make sure that the PSERVER NLM (NetWare Loadable Module) is loaded on
your file server.
2. Log into the file server from your PC workstation as ADMIN if you are using
NetWare 4.xx (if you want NDS support, do not login under bindery mode). If
you are using NetWare 2.XX or 3.xx, login as SUPERVISOR.
3. Run the PCONSOLE utility from your PC workstation.
4. If you are creating a new print queue, select Print Queue Information
(NetWare 3.xx) or Print Queues (NetWare 4.xx) from the Available Options
menu. Press INSERT, type in the desired print queue name (with NetWare
4.xx, you will also be asked for a volume name; press INSERT and select the
appropriate volume), and press ESCAPE to return to the main menu.
The following steps apply to configuring a remote printer with NDS support on
NetWare 4.xx systems: