Panasonic AG-HPX500E - Manual (Page 93)

93
Mounting and Adjusting the Lens
C
h
ap
te
r 5 P
re
p
ar
at
io
n
3
Use the JOG dial button to select
DEFAULT, USER1, USER2, USER3 or
OFF and press the JOG dial button.
• To adjust the white shading, select USER1,
USER2 or USER3.
• The USER1, USER2 or USER3 settings do
not contain any compensation data by default.
• Store compensation data that suits
KJ16ex7.7B IRSD PS12 and KJ16ex7.7B
KRSD PS12 in DEFAULT. For lenses other
than those above, perform the “White
Shading Adjustment” described below.
PUSH MENU TO RETURN
SHADING(USER)
SHADING SELECT
LENS SETUP
DEFAULT
CAC PROPERTY
CAC CARD READ
CAC FILE DELETE
CAC FILE INIT
IRIS ADJUST OFF
USER1
USER2
USER3
OFF
White Shading Adjustment
<Note>
Coloring may occur in the vertical direction near the
open setting of the lens iris even when the white shading
has been adjusted. This is an optical characteristic and
not indicative of a failure.
1
Place the camera in the adjustment
mode.
(1) Mount a lens on the camera.
• Do not forget to connect the lens cable.
(2) Turn off the electronic shutter and set the
gain to L (0 dB).
(3) If the lens comes with an extender,
disengage it.
(4) Open the setting menu LENS SETUP
screen and select USER1, USER2 or
USER3 under SHADING SELECT.
(5) Use the JOG dial button to select
SHADING (USER), select YES and press
the JOG dial button.
• The message “CHECK LUMINANCE
LEVEL ZEBRA ON VF” appears.
PUSH MENU TO RETURN
SHADING(USER)
SHADING SELECT
LENS SETUP
USER1
CAC PROPERTY
CAC CARD READ
CAC FILE DELETE
CAC FILE INIT
IRIS ADJUST OFF
YES
YES
NO
CHECK LUMINANCE LEVEL
PUSH DIAL
ZEBRA ON VF
SHADING: USER1 SET OK?