Nortel Networks 608(WL) - Manual (Page 117)

Chapter 4
Configuration via the Command Line Interface
E-DOC-CTC-20051017-0169 v0.1 115
4.3.3 Create a New Peer Security Descriptor
add command A new Peer Security Descriptor is created with the ipsec peer descriptor
add command.
Example In the following example, a new Peer Security Descriptor is created, named
peerdes1
The result of this operation can be verified with the list command.
It is seen that the new descriptor, named “peerdes1”, has been created but no
parameters are assigned yet.
=>ipsec
[ipsec]=>peer
[ipsec peer]=>descriptor
[ipsec peer descriptor]=>add
name = peerdes1
:ipsec peer descriptor add name=peerdes1
[ipsec peer descriptor]=>
[ipsec peer descriptor]=>
[ipsec peer descriptor]=>list
[AES_SHA1] : AES(128) SHA1 MODP1024 Lifetime 3600s
[AES_MD5] : AES(128) MD5 MODP1024 Lifetime 3600s
[3DES_SHA1] : 3DES SHA1 MODP1024 Lifetime 3600s
[3DES_MD5] : 3DES MD5 MODP1024 Lifetime 3600s
[DES_SHA1] : DES SHA1 MODP768 Lifetime 3600s
[DES_MD5] : DES MD5 MODP768 Lifetime 3600s
[AES_SHA1_Adv] : AES(256) SHA1 MODP1536 Lifetime 86400s
[peerdes1] :
[ipsec peer descriptor]=>
Seven Peer Security Descriptors are pre-defined in the SpeedTouch™,
covering the most common settings. In total, up to 40 Security Descriptors
can be defined. This total includes both the
Peer Security Descriptors and
the Connection Security Descriptors (see “4.5 Connection Security
Descriptor” on page 127 ).