Nortel Networks 608(WL) - Manual (Page 143)

Chapter 4
Configuration via the Command Line Interface
E-DOC-CTC-20051017-0169 v0.1 141
4.7 Connection
What is ... A Connection bundles all the parameters required for the PH2 SA negotiation:
 Peer
Reference, pointing to the peer configuration to be used. In fact, this refers to
the IKE channel used for the Phase 2 negotiations.
 Local/remote range
Range of private IP addresses to which the IPSec policy applies.
Reference to the Network Descriptors or expressed by a dynamic policy.
 Connection Security Descriptor
Reference to the Phase 2 Security Descriptor grouping the security
parameters.
The Connection parameters are explained in section 4.7.1 .
How is it used A Connection can be successfully configured from the moment when a Connection
Security Descriptor is present in the SpeedTouch™.
The local and remote private networks can be described either by a valid Network
Descriptor, or by a
keyword present in the SpeedTouch™. When the IPSec policy is
expressed as a static policy, a Network Descriptor describes the local and remote
private networks. As a consequence, some valid Network Descriptors must be
defined prior to the successful definition of a Connection.
When using a dynamic policy, the networks are described by keyword (see section
4.7.1 ).
In this section The following topics are discussed in this section:
Topic Page
4.7.1 Connection Parameters 142
4.7.2 List all Connections 145
4.7.3 Create a New Connection 146
4.7.4 Set or Modify the Connection Parameters 147
4.7.5 Delete a Connection 148
4.7.6 Start a Connection 149
4.7.7 Stop a connection 150