Remote identifier [remoteid, Chapter 4 – Nortel Networks 608(WL) User Manual
Page 123
Chapter 4
Configuration via the Command Line Interface
E-DOC-CTC-20051017-0169 v0.1
121
Remote Identifier
[remoteid]
This parameter identifies the remote Security Gateway during the Phase 1
negotiation. This identity must match the settings in the remote Security Gateway in
order to successfully set up the IKE Security Association. The identity types
supported in the SpeedTouch™ are listed in the following table.
Identity type
Keyword
Examples
IP address
(addr)
10.0.0.1
0.0.0.0 (any IP address
accepted)
Fully qualified domain name
(fqdn)
sales.corporate.net
User fully qualified domain
name
(userfqdn)
*.corporate.net
Distinguished name
(dn)
dc=corpor,uid=user
Key identity
(keyid)
cisid
any
(any)
In order to make the configuration of a VPN server independent of the
number of VPN clients, wildcards can be used in the userfqdn, as shown in
the table above. For example, *.corporate.net will match with any e-mail
address in the domain corporate.net.
The use of wildcards allows simultaneous connections with multiple VPN
clients, derived from a single peer profile.