Nortel Networks 608(WL) - Manual (Page 158)

Chapter 4
Configuration via the Command Line Interface
E-DOC-CTC-20051017-0169 v0.1 156
4.8.3 Clear Command Group
What is it used for This command group comprises two commands, intended for clearing Security
Associations:
 clear all
 clear session
The clear command group is accessed in the following way:
clear all This command clears all active Phase 1 and Phase 2 Security Associations for all
defined peers. The command has no associated parameters. The successful
execution of the command is notified to the user.
clear session This command clears the IKE Security Association and all active Phase 2 Security
Associations for one particular peer.
The peer is indicated by its name. The result of the command is notified to the user.
In the following example no Security Association was active for the peer, named
peer1, at the time of execution of the command:
=>
=>ipsec
[ipsec]=>clear
[ipsec clear]=>
[ipsec clear]=>all
ok.
[ipsec clear]=>
After clearing, the individual Security Associations can be established
again, either by starting connections, or triggered by traffic complying with
the policy.
[ipsec clear]=>session
name = peer1
:IPSec clear session name=peer1
Failed to find session for peer peer1
[ipsec clear]=>