Nortel Networks Passport ARN Routers - Manual (Page 101)

Configuring the ARN for Netboot and Directed Netboot
114200-E Rev 00 A-5
Configuring a Token Ring Interface for Network Booting
To configure an ARN token ring interface for network booting, use the following
command format:
ifconfig [ -d ] [ -r < speed > ] <interface> [<IP_address> <subnet_mask>
[ <next_hop_address>]]
Table A-3 describes the ifconfig command settings for configuring the router
token ring interface.
Table A-3. Token Ring Interface ifconfig Command Settings
Setting Description
Default Setting
-d Resets the router IP interface settings to the default values. Resetting
a token ring interface makes it inactive in the network booting process.
(The output of the getcfg command shows the default as None.)
IP Connector Setting
-r <speed> Specifies the speed of the token ring interface. Enter either 16 or 4
(Mb/s). The default is 16 Mb/s.
<interface> Specifies the IP connector you are configuring. Use the format
mau<
port #>.
IP Address Settings
<IP_address> Specifies the IP address of the interface you set with <interface>.
Provide this address in dotted decimal notation.
<subnet_mask> Specifies the IP subnet mask of the interface you set with <interface>.
Provide this address in dotted decimal notation.
<next_hop_
address> Specifies the IP address of the next-hop router. Provide this address in
dotted decimal notation. Specify this address only if there are
intermediate routers between the router and the BootP server.