Nortel Networks Passport ARN Routers - Manual (Page 50)

Installing and Operating Passport ARN Routers
1-26 114200-E Rev 00
When you have the appropriate equipment, complete the following steps:
1. Turn on and configure the terminal, using the parameters in Table 1-3
and the terminal user guide.
2. Turn off the terminal.
3. Insert the 9-pin receptacle end of the console cable into the ARN Console
connector.
4. Attach the null modem crossover adapter to the 25-pin connector.
Insert the screw on the cable connector into the receptacle on the adapter
connector and tighten the screw (refer to
Figure 1-20 on page 1-24 ).
5. Attach the 25-pin receptacle connector on the combined cable and
adapter to the console host connector
(Figure 1-22) .
Figure 1-22. Connecting a Terminal Console to an ARN
Table 1-3. Console Parameters
Parameter Value
Baud Rate 9600
Data Bits 8
Stop Bits 1
Parity None
COMM
20 mA PR KB
Console cable plus
null modem adapter
ARN0058A
UL
UL
100-240~ 1.2A 50-60Hz
Console Modem
Redundant Power