Nortel Networks Passport ARN Routers - Manual (Page 123)

Using Local Boot (the Quick-Start Procedure)
114200-E Rev 00 B-17
5. Type the following command and press the Return key:
run inst_arn.bat
6. Follow the script online, using your worksheets when responding to its
prompts.
The list of commands in Table B-2 describe how to interact with the
Quick-Start script.
The script prompts you for the following information (in the order given):
a. The initial Global Worksheet information
b. Specific protocol information
c. Wide area protocol selection
d. Specific protocol information
e. The rest of the Global Worksheet information
After you enter all of the Global Worksheet protocol information, the script
displays a Configuration Summary and prompts you to save the configuration
to a file.
Table B-2. Quick-Start Commands
Task Action Details
Accept a default value Press Return Your console displays default values in
brackets; for example, [E11].
Repeat a step (for
example, if you make a
mistake) Press Control-c
Press n When prompted, “Terminate script y/n?”
press the n key. You return to the
beginning of the step so that you can
reenter the information.
Stop the Quick-Start
installation procedure Press Control-c
Press y When prompted, “Terminate script y/n?”
press the y key. The procedure is
terminated and you return to the
Technician Interface prompt.
To restart the Quick-Start/Power-Start
procedure, you must reboot the router by
entering
boot .