Nortel Networks Passport ARN Routers - Manual (Page 82)

Installing and Operating Passport ARN Routers
3-10 114200-E Rev 00
• After the boot process completes, the Run LED lights and the Boot LED turns
off, indicating that the ARN is operational.
If the LEDs on the ARN light in this sequence, your installation is successful.
Contact your network administrator to verify that the ARN is now connected to
the network.
If the LEDs do not light in this sequence, your network administrator can refer to
Configuring Remote Access for AN and Passport ARN Routers to help
troubleshoot the problem.
If you need additional assistance, contact your local Nortel Networks Technical
Solutions Center.
Table 3-15. Boot Status LEDs
Boot Status Run LED Boot LED
Local Boot Off On
Netboot (attempting) Off Flashing
Netboot (downloading) Flashing On
Interrupted (using ARN monitor) Flashing Flashing
Note: If the ARN does not contain an expansion module, an adapter module, a
redundant power supply, a data collection module, or a flash card, the LEDs
associated with these components remain off.