Nortel Networks Passport ARN Routers - Manual (Page 109)

Using Local Boot (the Quick-Start Procedure)
114200-E Rev 00 B-3
Table B-1 provides the connector names and numbers you should use during the
Quick-Start procedure.
Filling Out the Worksheets
The inst_arn.bat script provides many options for configuring the ARN on a
network. Since typical remote access uses a serial interface over a wide area
connection, this sample describes only the options involved with a serial
configuration.
We suggest the following procedure when you fill out worksheets:
1. Fill out the Global Information Worksheet completely.
The sample worksheet lists options common to all serial interface
configurations.
2. After you record your protocol selections on the Global Information
Worksheet, fill out one Router Protocol worksheet.
Table B-1. Quick-Start Connector Names and Numbers
Module
Interface*
* The Quick-Start script does not support initial ISDN, X.25 PAD, or V.34 interface
configuration.
Base Expansion Adapter 1 Adapter 2
Ethernet XCVR1 XCVR2 N/A N/A
Token Ring MAU1 MAU2 N/A N/A
Serial N/A COM3, COM4,
or COM5 COM1 COM2
56/64K, FT1/T1, or
FE1/E1 DSU/CSU N/A N/A COM1 COM2
Note: This section provides worksheets only for a serial interface
configuration over a wide area connection. It does not contain worksheets for
LAN configuration options. If configuring a LAN interface, read the
Quick-Start text and prompts carefully before responding, as they will differ
from the serial sample.