National Instruments AT-MIO-16X User Manual
Page 315
Index
AT-MIO-16X User Manual
I-6
© National Instruments Corporation
Configuration Memory Depth Field
(figure), 6-5
EEPROM map, 6-2
factory area information (table),
6-2 to 6-4
Revision and Subrevision field
(figure), 6-5
storage area, 6-4
equipment requirements, 6-7 to 6-8
input calibration, 3-7 to 3-8
output calibration, 3-17 to 3-18,
6-10 to 6-11
reference calibration, 6-8 to 6-9
CFGMEMEF* bit, 4-29
CHAN_AIS bit, 4-35
CHAN_BIP bit, 4-36
CHAN_CAL bit, 4-35
CHAN_DSP bit, 4-38 to 4-39
CHAN_GHOST bit, 4-38
CHAN_LAST bit
description, 4-38
programming multiple-analog input
channel configurations, 5-15
channel scanning. See data acquisition
programming.
CHAN_SE bit, 4-35
CHANSEL<3..0> bits, 4-36 to 4-37
CH_GAIN<2..0> bits, 4-37 to 4-38
CLKMODEB<1..0> bits, 4-20 to 4-21
CNT32/16* bit
description, 4-7 to 4-8
sample counting, 5-18, 5-19
Command Register 1, 4-5 to 4-8
Command Register 2
description, 4-9 to 4-12
interrupt programming, 5-43
programming digital I/O circuitry, 5-36
Command Register 3, 4-13 to 4-19
Command Register 4, 4-20 to 4-24
common-mode signal rejection, 2-29
ComponentWorks software, 1-4
concatenating counters, 2-39
CONFIGCLK signal, 3-29
CONFIGMEM Register
description, 4-35 to 4-40
programming
multiple-analog input channel
configurations, 5-16
single-analog input channel
configurations, 5-15
CONFIGMEMCLR Register
description, 4-47
programming
multiple-analog input channel
configurations, 5-16
single-analog input channel
configurations, 5-15
CONFIGMEMLD Register
description, 4-48
programming
multiple-analog input channel
configurations, 5-16
single-analog input channel
configurations, 5-15
configuration. See also input configurations;
installation; signal connections.
analog input, 2-7 to 2-11
considerations for selecting input
ranges, 2-10
input modes, 2-7 to 2-10
input polarity and range, 2-10 to 2-11
analog output, 2-11 to 2-12
output polarity selection, 2-12
reference selection, 2-11
AT bus interface, 2-2 to 2-3
base I/O address selection, 2-3 to 2-6
changing software to match
(note), 2-4
default settings of National
Instruments products (table),
2-4 to 2-5