National Instruments AT-MIO-16X User Manual
Page 322
Index
© National Instruments Corporation
I-13
AT-MIO-16X User Manual
I
immediate update mode, 3-18
input configurations. See also CONFIGMEM
Register.
available input modes, 2-7 to 2-10
DIFF (table), 2-8
NRSE (table), 2-8
RSE (table), 2-8
common-mode signal rejection, 2-29
differential connections
DIFF input configuration, 2-22
floating signal sources, 2-24 to 2-26
ground-referenced signal
sources, 2-23
nonreferenced signal sources,
2-24 to 2-26
recommended configuration (table), 2-22
single-ended connections, 2-26 to 2-27
floating signal sources (RSE
configuration), 2-27
grounded signal sources (NRSE
configuration), 2-28
input multiplexer
address selection bits (CHANSEL
<3..0>), 4-36 to 4-37
description, 3-6
input polarity and range, 2-10 to 2-11
actual range and measurement precision
(table), 2-11
selection considerations, 2-10
installation. See also configuration.
hardware installation, 2-13
unpacking AT-MIO-16X, 1-7
INTCHB<2..0> bits, 4-19
internal update counter, selecting, 5-32
interrupts
controlling with bits in Command
Register 3, 4-13 to 4-19
interrupt channel selection, 2-7
interrupt level selection (table), 4-19
PC I/O channel interface, 3-4
programming, 5-43
interval channel scanning
definition, 5-10
programming, 5-12 to 5-14
interval scanning data acquisition timing, 3-14
INTGATE bit, 4-6
I/O connectors
cabling considerations
50-pin I/O connector, 2-43 to 2-44
68-pin I/O connector, 2-44
exceeding maximum ratings
(warning), 2-14
pin assignments
50-pin connector (figure), 2-15, B-2
68-pin connector (figure), 2-16, B-3
signal descriptions (table), 2-17 to 2-19
I/O_INT bit, 4-15
L
LabVIEW and LabWindows/CVI
software, 1-4
LASTONE bit, 5-16
linear errors
equivalent gain errors in 16-bit systems
(table), A-4
equivalent offset errors in 16-bit systems
(table), A-3
gain error, A-3
postgain offset error, A-3
pregain offset error, A-3
M
manual. See documentation.
multiple-analog input channel configurations,
programming, 5-15 to 5-16
multiple-channel data acquisition timing,
3-12 to 3-15
continuous scanning, 3-13