National Instruments NI-FBUS User Manual
Page 154
Index
© National Instruments Corporation
I-7
NI-FBUS Configurator User Manual
ITK_VER parameter, 4-21
L_TYPE parameter, 4-22
linearization types (table), 4-22
LIM_NOTIFY parameter, 4-22
limiting parameters (table), 4-7
LO_ALM parameter, 4-22
LO_LIM parameter, 4-23
LO_LO_ALM parameter, 4-23
LO_LO_LIM parameter, 4-23
LO_LO_PRI parameter, 4-23
LO_PRI parameter, 4-23
LOW_CUT parameter, 4-23
MANUFAC_ID parameter, 4-23
MAX_NOTIFY parameter, 4-23
MEMORY_SIZE parameter, 4-23
MIN_CYCLE_T parameter, 4-24
mode shedding parameters, 4-8
MODE_BLK parameter, 4-24
field modes (table), 4-24
operational modes (table), 4-24
monitoring, 2-30
network parameters, setting, 2-26
NV_CYCLE_T parameter, 4-25
option parameters, 4-8
OUT parameter, 4-25
OUT_D parameter, 4-25
OUT_HI_LIM parameter, 4-26
OUT_LO_LIM parameter, 4-26
OUT_SCALE parameter (table), 4-26
OUT_STATE parameter, 4-26
PID scaling procedure, 4-6
process parameters, 4-9
PV parameter, 4-26
PV_D parameter, 4-26
PV_FTIME parameter, 4-27
PV_SCALE parameter, 4-27
PV_STATE parameter, 4-27
RA_FTIME parameter, 4-27
RATE parameter, 4-27
RCAS_IN parameter, 4-27
RCAS_IN_D parameter, 4-27
RCAS_OUT parameter, 4-28
RCAS_OUT_D parameter, 4-28
READBACK parameter, 4-28
READBACK_D parameter, 4-28
reading using TAG.PARAM access
RESET parameter, 4-28
RESTART parameter, 4-28
ROUT_IN parameter, 4-29
ROUT_OUT parameter, 4-29
RS_STATE parameter, 4-29
SEL_1 through SEL_3 parameter, 4-29
SEL_TYPE parameter, 4-29
SET_FSTATE parameter, 4-29
SHED_OPT parameter, 4-30
SHED_RCAS parameter, 4-30
SHED_ROUT parameter, 4-30
SIMULATE parameter, 4-30
SIMULATE_D parameter, 4-30
SP parameter, 4-31
SP_D parameter, 4-31
SP_HI_LIM parameter, 4-31
SP_LO_LIM parameter, 4-31
SP_RATE_DN parameter, 4-31
SP_RATE_UP parameter, 4-31
ST_REV parameter, 4-31
STATUS_OPTS parameter, 4-32
STRATEGY parameter, 4-33
TAG_DESC parameter, 4-33
TEST_RW parameter, 4-33
TRK_IN_D parameter, 4-33
TRK_SCALE parameter, 4-33
TRK_VAL parameter, 4-33
tuning parameters, 4-10