National Instruments NI-FBUS - Manual (Page 93)

Chapter 4 Parameters
NI-FBUS Configurator User Manual 4-28 ni.com
RCAS_OUT (Process)
The back calculation output used by the supervisory host when establishing
a Remote cascade loop.
RCAS_OUT_D (Process)
The discrete back calculation output used by the supervisory host when
establishing a Remote cascade loop.
READBACK (Scaling, Tuning)
The valve or actuator position read back from the transducer, in transducer
units.
READBACK_D (Scaling, Tuning)
The transducer state for the actual discrete valve or actuator position.
RESET (Tuning)
The time constant for the integral component of the PID block. It is
measured in seconds per repeat (so larger values have less effect, and
INF
effectively disables the integral term).
RESTART (Diagnostic, Option)
Allows the user to restart the device remotely.
Caution Using Restart to Defaults causes all your configured parameters in the
FP-3000 to revert to their factory default settings.
Table 4-19. Restart Values
Value Behavior
Restart Resource Restarts the device.
Restart to Defaults Restarts the device, restoring all parameter values to default values.
Restart Processor Restarts the device as if the power was cycled.