Ricoh 1075 - Manual (Page 100)

User Tools (System Settings)
86
5
Interface Settings/Parallel Interface
❖ ❖ ❖ ❖ Parallel Timing
Specifies the timing setting for the parallel interface. Under normal circum-
stances, you will not need to change this setting.
Note
❒ Default setting: ACK outside
❖ ❖ ❖ ❖ Parallel Communication Speed
Specifies the communication speed of the parallel interface. If the communi-
cation speed is set too fast, data transfer may not flow smoothly. If this occurs,
change the setting to “Standard”.
Note
❒ Default setting: High speed
❖ ❖ ❖ ❖ Selection Signal Status
Specifies the signal setting of the parallel interface.
Note
❒ Default setting: High
❖ ❖ ❖ ❖ Input Prime
Specifies whether the prime signal is active or inactive when an input prime
signal is sent. Under normal circumstances, you will not need to change this
setting.
Note
❒ Default setting: Invalid
❖ ❖ ❖ ❖ Bidirectional Communication
Specifies the printer's response mode and so forth for a status request when
using the parallel interface. If you experience problems when using other
manufacturers, printers, set this to “OFF”.
Limitation
❒ If this is set to “OFF”, bidirectional communication functions will not
work.
Note
❒ Default setting: ON
❖ ❖ ❖ ❖ Signal Control
Specifies the error processing settings for when an error occurs when printing
from a computer. Under normal circumstances, you will not need to change
this setting.
Note
❒ Default setting: Job acceptance priority
MartiniC1_GBzen2_FM.book Page 86 Friday, April 19, 2002 2:18 PM