Ricoh 1075 - Manual (Page 53)

Configuring the Network
39
2
A Make sure that the [Network] key is selected, and then press the [NW Frame
Type] key.
B Select the Frame Type, and then press the [OK] key.
When using the IEEE 1394 Interface (option)
Note
❒ When you use the IEEE 1394 Interface, you cannot use the DHCP. You
must set the fixed IP address.
❒ Be sure to set the IP over 1394 to “Effective”. The default is set to “Effec-
tive”.
Reference
When you use parallel printing, see the Printer Reference.
A Make sure that the [Network] key is selected, and then press the [IEEE 1394]
key.
B Press the [IP Address] key.
C Use the number keys to enter the IP address, and then press the [OK] key.
D Press the [Sub-net Mask] key.
E Use the number keys to enter the Subnet Mask, and then press the [OK]
key.
F Press the [IP over 1394] key.
G Make sure that [Active] is selected, and then press the [OK] key.
Note
❒ If [Active] is not selected, press the [Active] key, and then press the [OK]
key.
MartiniC1_GBzen2_FM.book Page 39 Friday, April 19, 2002 2:18 PM