Ricoh 1075 - Manual (Page 98)

User Tools (System Settings)
84
5
❖ ❖ ❖ ❖ Set Time
Set the time for the copier's internal clock using the number keys.
Note
❒ To change between hours, minutes and seconds, press the [← ← ← ←] and [→ → → →] keys.
❖ ❖ ❖ ❖ Weekly Timer Code
Sets an 8-digit code to turn on the main power during a time frame in “Week-
ly Timer”.
Note
❒ Default setting: OFF
❒ If “ON” is selected, enter the timer code.
❒ If “ON” is selected without entering the timer code, the machine cannot be
used, even if the power is turned on. If “Off” is selected, the machine can
be used without entering a timer code, when it is turned on.
❖ ❖ ❖ ❖ Weekly Timer: (Monday-Sunday)
Set the power on timer using the number keys.
Interface Settings/Network
❖ ❖ ❖ ❖ IP Address
Before using this machine with the network environment, you must config-
ure the IP address.
Note
❒ Default setting: 011.022.033.044
❒ Do not use an IP address that is used for another machine. To get the ad-
dresses, contact your network administrator.
❒ If you install the IEEE 1394 Interface Board (option) and use the IEEE 1394
interface, you must set the address of the domain, different from the IP ad-
dress of [IEEE 1394]. If you intend to set the address for the same domain,
set a different value for the Sub-net Mask.
❒ Press the [← ← ← ←] or [→ → → →] key to move in 3-digit increments.
❒ Press the [Clear] key when the wrong address is entered.
❖ ❖ ❖ ❖ Sub-net Mask
This is a number used to mathematically “mask” or hide an IP address on the
network by eliminating those parts of the address that are alike for all ma-
chines on the network.
Note
❒ Default setting: 000.000.000.000
❒ Press the [←
← ← ←] or [→ → → →] key to move in 3-digit increments.
❒ Press the [Clear] key when the wrong address is entered.
MartiniC1_GBzen2_FM.book Page 84 Friday, April 19, 2002 2:18 PM