Ricoh 1075 - Manual (Page 102)

User Tools (System Settings)
88
5
❖ ❖ ❖ ❖ Bidirectional SCSI print
Specifies the printer's response mode and so forth for a status request when
using the IEEE 1394 interface.
Note
❒ Default setting: ON
❒ If this is set to “OFF”, bidirectional communication functions will not
work.
Interface Settings/IEEE 802.11b (option)
Preparation
You must install the Wireless LAN board (option) into the machine.
Note
❒ Be sure to make all settings simultaneously.
❖ ❖ ❖ ❖ Communication Mode
Specifies the communication mode of the Wireless LAN.
Note
❒ Default setting: 802.11 Ad hoc
❖ ❖ ❖ ❖ SSID Setting
Specifies SSID to distinguish the access point in the Infrastructure mode.
Note
❒ Default setting: blank (ASSID)
❒ If blank is specified in 802.11b Ad hoc mode or Ad hoc mode, “ASSID” ap-
pears.
❖ ❖ ❖ ❖ Channel
Specifies a channel when you select 802.11b Ad hoc mode or Ad hoc mode.
Note
❒ Default setting: 11
❒ The channel can be set from 1 - 13.
❖ ❖ ❖ ❖ Wireless LAN Signal
Shows the radio-wave conditions of the access point connected in Infrastruc-
ture mode.
Note
❒ Radio wave status is shown when you press the [Wireless LAN Signal] key.
MartiniC1_GBzen2_FM.book Page 88 Friday, April 19, 2002 2:18 PM