Ricoh 1075 - Manual (Page 52)

Basics
38
2
Acquiring the IP Address from the DHCP Server
To use the DHCP server to acquire the IP address, select [DHCP] from [Network
Boot]
.
Note
❒ You need to make settings when you use DHCP. See “Using DHCP” in the
Network Printing Guide.
❒ To always assign the same IP address to the machine, reserve the IP ad-
dress for the machine on the DHCP server. See “Using DHCP” in the Net-
work Printing Guide.
❒ Use the default IP address.
A Make sure that the [Network] key is selected, and then press the [Network
Boot] key.
B Press the [DHCP] key, and then press the [OK] key.
When using NetWare
To use the machine on NetWare, be sure to select the type of [NW Frame Type].
You can select the following frame types:
• Auto Select (Default)
• Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
Note
❒ Make sure to select the frame type same as the file server.
❒ When you select “Auto Select”, the frame type detected upon startup is au-
tomatically set. Therefore, your desired frame type may not be selected by
the system, which supports multiple frame types. Select the desired frame
type.
❒ To use the machine in a pure IP environment on NetWare 5/5.1, select [Ef-
fective] for TCP/IP in step D .
MartiniC1_GBzen2_FM.book Page 38 Friday, April 19, 2002 2:18 PM