Quadra-Fire Castile Pellet Insert CASTILEI-MBK - Manual (Page 19)

R
January 19, 2011 7022-122 Page 19
Castile Pellet Insert
C. Door Handle Removal
1. Open the outer door.
2. Unlatch and open the fi rebox door.
3. Continue to turn handle until it is free from the fi rebox
door.
D. Door Removal
1. Open the outer door.
2. Unlatch and open the fi rebox door.
3. Lift the fi rebox door up, freeing it from the fi rebox hinges.
E. Adjustable Hearth Support
Size: 9”d x 45”w, 2” to 10” Height Adjustment
Included in Kit: (1) trim top, (1) trim front, (2) trim sides,
double-sided tape (already installed)
Tools Needed: Phillips head screwdriver, sheet metal
shears, measuring tape, gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. Figure 19.1.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips head screwdriver.
3. Measure front and side trims to required height
to cover scissors and mark pieces for cutting. Cut
excess material from top of trim’s edge, not bottom.
This edge will be sharp; wear gloves to prevent injury
to your hands. The cut edge fi ts under lip of top trim,
so it allows for some variance in your straight edge.
Figure 19.2.
4. The double-sided tape that holds front and side trims
to scissors has a powerful bonding adhesive. Adjust-
ments are extremely diffi cult once trim has adhered to
tape. Do a dry run fi rst without removing paper from
tape.
5. Place cut edge of trim under top lip and into position
on scissors. Place side pieces on fi rst and then front
piece. The front piece overlaps side pieces.
6. Once you are satisfi ed with the positioning, remove
trim and set aside.
7. Remove the paper from double-sided tape that is
to accept trim side. Align side and then press hard
against tape to secure side piece. Repeat for other
side. Install front trim piece last.
8. There are 3 holes in the back fl ange of the top to
secure it to the wall if necessary. Use the appropriate
fastener for the type of wall material, i.e., brick, sheet-
rock, etc.
NOTE: 3/8 inch (9.5mm) thick tile or like material can be
cut to size and fi t under lip of top trim edge for a decora-
tive touch. Figure 20.3.
Figure 19.1
Figure 19.2
Figure 19.3
WARNING
Sheet metal trim edges will be sharp.
For safety purposes wear gloves.
Injury can occur.
DOUBLE-SIDED TAPE DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
Decorative tile
may be installed
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGHT
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE