Castile pellet insert, Re-installing baffl e & brick set, I. baffl e & brick set removal – Quadra-Fire Castile Pellet Insert CASTILEI-MBK User Manual

Page 39

Advertising
background image

R

January 19, 2011

7022-122

Page 39

Castile Pellet Insert

Brick is flush against back wall

Notches

exposed

Re-installing Baffl e & Brick Set

1. Place right brick in behind the right bracket, and then

slide to the left so the tabs are behind the center brick.

Figure 39.4.

2. The brick will be fl ush against the back wall and notches

exposed in the side bracket.

Figure 39.5.

3. Lift slightly and pull the right edge of the brick forward until

it stops and then drops down into both top and bottom

notches of right bracket and locks into place.

Figures

39.1 and 39.2.

4. Repeat for left brick.
5. Insert baffl e into top front inside the fi rebox and pull for-

ward. Then raise up the bottom end and insert baffl e tab

into slot on the top of the right bracket to lock into place.

Figure 39.3. Place the left side hook at the bottom of the

baffl e over the top edge of brick for stability.

Figure 37.4.

6. The baffl e does not completely cover the top of the fi rebox.

There is an opening on the left as shown in

Figure 40.5 on

page 40.
NOTE: Improper installlation can cause poor appli-

ance performance.

Tabs

Figure 39.4

Figure 39.5

I. Baffl e & Brick Set Removal

1. Follow proper shutdown procedures in Section 10.
2. The top baffl e has a hook on the bottom left side that

rests on the top lip of the cast brick. There is a tab on

the bottom right side that hooks into the side bracket.

Remove the top baffl e by fi rst pulling the baffl e forward

until back edge drops down. Then slide baffl e back and

down until the front edge clears the shelf that it had been

resting on.

Figure 39.1.

3. The top baffl e must be removed before you can remove

the right and left brick. Remove the right brick by hold-

ing top lip of brick and lifting up, then push outside edge

back. Slide brick to the right until it is fl ush with the fi rebox.

Rotate the inside edge of the brick forward and remove

brick. Repeat for left brick.

Figure 39.2.

Remove Right

& Left Brick

Vacuum

Exhaust Area

Right Brick

Removed

Figure 39.1

Figure 39.2

Figure 39.3

Advertising