Quadra-Fire Castile Pellet Insert CASTILEI-MBK - Manual (Page 23)

R
January 19, 2011 7022-122 Page 23
Castile Pellet Insert
(4) Felt Vibration Insulation Pads
Secure
Surrounds to
Cast Trim Kit
Attach Magnet
before installing
Cast Footers
Magnet Installed
Cast Footers,
Left & Right
Back
of
Side
Piece
Magnet Attached - Faces Front
Clearance Notch
Figure 23.2
Figure 23.3
Surround Set
attaches to top
and bottom of
insert sides.
Thumb
Screw
Bracket
Figure 23.1
Figure 23.4
1. Open door to expose the fi rebox.
2. Install the left log fi rst and then the right log.
Figure 23.1
3. Lean the logs against the cast iron brick in the back of
the fi rebox.
4. Push the logs to the far left and far right against the
sides of the fi rebox. Figure 23.2.
5. To clean the logs, use a vaccum cleaner and a soft
brush attachment or a paint brush.
Two Piece Log Set Installation
Figure 23.6
I. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fi re, the
logs are not covered under warranty. Any placement vari-
ation other than shown here can cause excessive heat
and shall void the appliance warranty.
Figure 23.5
H. Surround and Cast Trim Set (Cont’d)