4-2. electrical work, Caution – Toshiba RAS-10SAX User Manual

Page 23

Advertising
background image

– 23 –

<When the installation plate is directly mounted

on the wall>

(1) Securely fit the installation plate onto the wall by

screwing it in the upper and lower parts to hook

up the indoor unit.

(2) Install the installation plate horizontally in the wall.

(3) To mount the installation plate on a concrete wall

with anchor bolts, utilize the anchor bolt holes as

shown in the above figure.

CAUTION

When installing the installation plate with mounting

screw, do not use the anchor bolt hole. Otherwise

the unit may fall down and result in personal injury

and property damage.

8-4-2. Electrical Work

(1) The supply voltage must be the same as the rated

voltage of the air conditioner.

(2) Prepare the power source for exclusive use with

the air conditioner.

Model

RAS-
10SK-E/
10SA-E
RAS-
10SKX/
10SAX

Maximum

running

current

7.5 A

Plug

socket

& fuse

rating

16 A

Wiring

1mm

2

or

more

Fig. 8-4-4

CAUTION

Failure to firmly install the unit may result in

personal injury and property damage if the unit

falls.

• In case of block, brick, concrete or similar type

walls, make 5 mm dia, holes in the wall.

• Insert

3

clip anchors for appropriate

8

mounting screws.

NOTE :

• Install the installation plate using 4 to 6 pieces of

mounting screw securing four corners with screws.

Installation plate
(Keep horizontal direction)

Anchor bolt

Projection
15mm
or less

5mm dia, hole

3 Clip anchor

8 Mounting screw ø4 x 25

Power source

50Hz

*220/230/240V~

Single-phase

* No adjustment is necessary.

CAUTION

• Use power specified in above table.

• This appliance can be connected to the mains

in either of the following two ways.

(1) Connecting the power cord to the main power

supply provided with a circuit breaker or switch

with a contact of 3 mm or more.

In this case, an approved circuit breaker or

switch must be used.

(2) Attaching a plug to the power cord and pluging

it in to the wall outlet.

In this case, an approved power cord and plug

must be used.

NOTE :

• Perform wiring works so as to allow a generous

wiring capacity.

Advertising
This manual is related to the following products: