Universal Laser Systems X2-600 - Manual (Page 102)

6-38 Sample Materials
with the laser system, add glue to the veneer, and apply the veneer into the engraved area of the other
piece of wood and let dry. After the glue has thoroughly dried, sand the veneer until it is flush with the
base wood. A good veneer to use is one with an adhesive backing. Once cut, place the veneer into its
proper place on the engraved wood block and with a clothes iron, and iron the veneer into the engraved
wood. This melts the glue and causes the veneer to stick to the engraved area. Finish the wood as you
desire and the finished product will look fantastic. The veneer can now be sanded flush with the surface
and a finish coat applied.
LASER ENGRAVING OR CUTTING WOOD CAN IGNITE THE MATERIAL. Never
leave the laser system running unattended for any reason.