Universal Laser Systems X2-600 - Manual (Page 60)

Options & Accessories 5-5
In the laser systems printer driver, use the same settings as the previous example but with only minor
modifications. In the “3D Effects” tab, select all three “Special” options; “Add Shoulder”, “Print as
Negative Image” and “Print as Mirror Image” as the diagram below illustrates.
Print to the laser system. Position the full sheet of rubber stamp material in the same upper left
location on the engraving table and begin engraving. The driver automatically adds the
shoulder, mirrors the entire page, and creates a negative image for engraving, and cuts out the
stamps.
Rotary Fixture
The Rotary Fixture has been designed to engrave cylindrical objects. Two attachments come with the
fixture, a cone shaped disk attached to the motorized end of the fixture and an inverted cone shaped disk
attached to the adjustable end of the fixture. These attachments are used to hold wineglasses, mugs,
cups, etc.