Universal Laser Systems X2-600 - Manual (Page 58)

Options & Accessories 5-3
Settings for a 30 Watt System
There is a considerable difference between rubber blends, thickness, and hardness between different
manufacturers. Use these setting as a starting point for a 30 Watt system. You might need to experiment
with different settings to obtain the desired results.
As you can see, we set the page size in the driver equal to the graphics programs page size. We also
selected "Add Shoulder” and “Normal Rubber Stamp”. We did not choose “Print as Negative Image” or
“Print as Mirror Image” because these switches are only used when printing a full sheet of stamps.
After making all driver selections, print the graphic to the laser system. Start engraving and watch the
stamp engrave and cut in the correct position on the rubber sheet. The background area, since it is
colored black is being engraved and the letters remain standing up. When the engraving part is done, the
stamp gets cut out along the red cut line due to the stronger settings that were assigned in the driver for
the color red.