Universal Laser Systems X2-600 - Manual (Page 48)

System Operation 3-23
If you find that you need to place your materials in a position other than the upper left hand corner, you
can change the default focus position to anywhere in the field that you like. Please refer to that menu
item selection earlier in this section.
The Material Thickness (Z POSITION) Method
The second method is to enter in the thickness of the material into the “Z POSITION” display. This
method does not involve the use of the focus tool. For example, using a caliper or some other thickness
measuring device, measure the thickness of your material and enter that thickness into the “Z POSITION”
display. For example, if your material is 1 inch thick, use the up or down arrow button to raise or lower
the table until the digital display reads “1.00”. That is all you need to do. Now press the “Z” button again
to bring the motion system back to the home position. The beam is now precisely focused on the surface
of your material. Think of it as using an imaginary focus tool.
The laser system table has been set up at the factory to read “0.00” when the beam is focused to the
surface of the table when the lens that is installed on the focus carriage matches the “CURRENT LENS”
in the display.
The factory has only set the “0.00” point for the lenses that you purchased at the time the system was
shipped. If you purchase additional lenses, you will need to set the “0.00” point, also called the “FOCAL
HEIGHT”, for each lens.
CURRENT LENS Menu
There are 4 lenses available, 1.5, 2.0, 2.5, and 4.0 inch lenses. All of them have different focal lengths so
this is why we need to have a different “FOCAL HEIGHT position for each lens. If you press the
“SELECT” button while the cursor is on this menu item, you will see the right side of the display toggle
into the different lens heights. You will also notice that the “Z POSITION” display change to reflect the
difference in focal lengths. If you have purchased all of the other optional lenses with the laser system, all
of the focal lengths have been set for you. If you just purchased the standard 2.0 lens, only that “FOCAL
HEIGHT” was set at the factory. This is due to the fact that all lenses have slightly different focal lengths
even if they are both 2.0 inch lenses so each one’s “FOCAL HEIGHT” must be calibrated on the machine.
SET FOCAL HEIGHT Menu
Use this selection to set the “0.00” for each lens. Using the focus tool that matches the “CURRENT
LENS” displayed, position the table so that the laser will be focused on the table’s surface. If the display
does not read “0.00”, move the cursor down to the “SET FOCAL HEIGHT” menu item and press the
“SELECT” button. The display will ask “ARE YOU SURE?”. Move the cursor down to “YES” and press
the “SELECT” button. The “Z POSITION” display will now read “0.00” and will be
PERMANENTLY
STORED IN MEMORY until you do this procedure again. If you have purchased other lenses, you can
set each of their focal heights by making that lens the “CURRENT LENS” and repeating this procedure.