Universal Laser Systems X2-600 - Manual (Page 106)

7-4 Maintenance
#2 Mirror
To gain access to the #2 Mirror, the mirror cover must be removed. Remove the thumbscrew, slide the
cover to the right slightly and lift straight up.
Inspect the #2 Mirror and clean it only if there is debris present. There are two ways to clean the mirror,
with a moistened cotton swab or a moistened lens tissue.
To clean the #2 Mirror with a cotton swab, moisten the cotton swab with the Lens Cleaning solution
supplied with the laser system.
DO NOT use other types of cleaners or solutions. Gently roll the cotton
swab across the mirror once. DO NOT drag the swab or roll it back and forth as this can scratch the
mirror. If the mirror did not come clean, use a fresh cotton swab and repeat the procedure. Do not worry
about small pieces of lint that come off of the cotton swab. They will be vaporized as soon as the laser
hits it. You can cause more damage to the mirror by trying to get it off than by leaving it alone.
The other method is to use a piece of lens tissue and the Lens Cleaning solution. Place a drop of
solution onto the lens tissue. Grasp the tissue by the edges and drag the moistened tissue across the #2
mirror in one direction. If the #2 mirror does not come clean in the first attempt, repeat the procedure with
a fresh piece of moistened lens tissue.
DO NOT re-use the same lens tissue twice and DO NOT put any
finger pressure on the surface of the mirror as this can scratch it.