Universal Laser Systems X2-600 User Manual
Page 49
3-24 System Operation
The AUTOFOCUS Method
In order to use this method, you must first turn it ON. We described how to turn it ON earlier in this
section. After you turn it ON, please follow the step by step instructions below.
To Use AUTOFOCUS:
•
The AUTOFOCUS sensor sends out an invisible beam across the table between the 1 inch and the 3
inch mark in the Y axis ruler for the M-300 Platform and the 2 and 4 inch mark for the V-400, X-600
and X2-600 Platform laser systems. You will notice that it is indented slightly.
•
Place your object between these two points vertically and anywhere on the table horizontally. Refer
to the diagram below.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
1
2
3
4
5
6
7
8
9
10
11
12
ENGRAVING TABLE
RULER INDENTATION
PLACE OBJECT ANYWHERE IN THIS AREA
AUTOFOCUS ZONE
R
E
F
L
E
C
T
O
R
S
E
N
S
O
R
•
Make sure that the laser system is in the main menu screen or the “File Display” menu. AUTOFOCUS
will not work in the other menus.
•
Press the “Z” button once on the control panel of the laser system. You will observe the Z-axis Table
(Engraving Table) move down and then up again, adjusting the table to the proper focusing height. If
the “Current Lens” choice in the menu system is not the same as the lens you have installed, correct
it by placing the cursor on the second line of the display, and pressing the “Select” button to toggle
you through your choices. Once the desired lens is displayed, escape out of the menu and
AUTOFOCUS again. This will bring the table up to the correct height. The display will now show that
the “Z Position” is “0.00” for that Focus Lens.
•
If you desire to adjust the “Z Position” so that you are slightly out of focus, without exiting out of the
menu, simply bring the cursor over to the “0.00” part of the display and adjust the table to the desired
offset. The display will now show you how much you are out of focus. If you were to escape out of
the display and perform the AUTOFOCUS procedure again, the “Z Position” will again show “0.00” to
remind you that you are precisely in focus.
•
If you have purchased additional lenses besides the 2.0 inch lens upon original delivery of the laser
system, those other lens heights have been set at the factory. If you purchase additional lenses after
you have received your machine and need to set the ‘Focal Height” of that lens, or you need to adjust
your AUTOFOCUS, please follow the next procedure.