Universal Laser Systems X2-600 - Manual (Page 31)

3-6 System Operation
The “NEXT FILE” button displays the next file in the systems memory and makes it the current file and will
stop at the last file in memory. The “PREV FILE” button displays the previous file in the systems memory
and makes it the current file and will stop at the first file in memory. These buttons are inoperative if a file
is currently running.
The Motion Control System
The motion control section of the control panel (the four directional arrow buttons) enables the user to
manually control motion system movement.
Pressing and holding down an arrow button will cause the focus lens assembly to move in the respective
direction. The motion system starts off slowly, but if you continue to hold down the button, you will see it
accelerate to a faster speed. Pushing the button once and letting it go quickly will move the motion
system in .001 inch increments. Pressing two adjacent buttons will move the assembly in a diagonal
direction. This part of the control panel is primarily used to position the focus lens assembly directly over
the engraving material and to use the focus tool to set the proper focus height. Other uses for these
buttons will be discussed later in this manual.
You must be in the “FILE DISPLAY” menu or the “MAIN” menu for this button to be operable. Pressing it
enables the “ORIGIN POSITION” menu to appear. It also turns on the optional red laser diode that
shows where the focus lens assembly is positioned in the field by shining a bright red “dot” on the
engraving area. Further details on how to use this button will be covered later in this section.
This button positions the focus carriage slightly away from the upper left hand corner at the default (1,1)
position in the engraving area. This is where the majority of focusing will be done. Once the focus
carriage is positioned, using the motion control arrow buttons can still move the motion system. Pressing
the button again will move the focus carriage back to the home position in the upper right corner of the
engraving area. You can set the default position to anywhere in the field that you desire. Relocating the
focus position is covered later on in this section.