Universal Laser Systems X2-600 - Manual (Page 107)

Maintenance 7-5
#3 Mirror and Focus Lens
You must remove the front cover to the Focus Carriage to gain access to the #3 Mirror and the Focus
Lens. To do this, hold the front cover with one hand and with the other hand, remove the three(3)
thumbscrews that attach the front cover to the Focus Carriage, and pull the front cover straight out. You
will notice that the #3 Mirror and the Focus lens are both mounted to the front cover. Refer to the
diagram below.
The #3 Mirror and the Focus lens are both glued to a metal bracket and the metal bracket is attached to
the front plate with Phillips head screws. It is not necessary to detach the bracket from either optic in
order to clean them. Simply tilt the front cover at enough angle so that you can apply the Lens Cleaning
solution directly to the #3 Mirror and to the Focus Lens. Flood the surfaces with the solution. If heavy
debris is present, let the solution soak in for a minute. Roll a fresh cotton swab across the #3 Mirror to dry
it off. Remember that it is okay if a small amount of lint from the cotton swab remains on the mirror.
Repeat this procedure for the Focus lens and always use a fresh swab.