Universal Laser Systems X2-600 User Manual
Page 77
Sample Materials
6-13
COMMENTS
If paint filling, mask the material first, then engrave through the masking. In this way, when ready to paint
fill, the material is already masked. Spray painting seems to be the easiest. Use the paint sparingly.
Excess paint can accumulate on the edges of the engraving, which will make mask removal difficult and
leave unsightly ridges. It is best to apply several lighter coats than one heavy coat of paint. Remove the
masking after the paint has dried.
ENGRAVING THIS MATERIAL PRODUCES ABRASIVE PARTICLES. Clean the laser
system more frequently to reduce wear and tear on the motion system components and
optics. Damage to the laser system from inadequate or insufficient maintenance
WILL
NOT be covered under warranty.