Acroprint ATR9800 - Manual (Page 34)

ATR9800 User Guide
32 Schedules
Accrue Towards Overtime: Can these additional hours accrue towards overtime? If so,
At Level: What OT level will these hours accrue at?
Exception Report Parameters
Exception report parameters are used to identify employees who do not follow punch rules.
Consecutive Hours Worked: Enter the number of consecutive hours worked, that if an
employee exceeds that amount it will be reported.
Overtime Hours Worked: Enter the number of consecutive overtime hours worked, that if an
employee exceeds that amount it will be reported.
Exception report intervals define a period of time in which the system reports the occurrence of
certain punches. Up to eight different report intervals can be defined. Report intervals can only
be used with keypad entries; this feature is not available for swipe and go. You can set up an
interval to see who is punching in too early, who is punching out late, etc.
Punch Type: Enter I to have this interval report an IN punch or O to have this interval report
an OUT punch.
Start Time: Enter the start time of the interval to report on a specific punch.
Stop Time: Enter the stop time of the interval to report on a specific punch.
In On Service
Minimum Hours: Enter the minimum hours an employee will be given for coming in using a
function key setup to be In On Service.
Accrue at Overtime: Y indicates the total time the employee is on service accrues to overtime.
Pay Overtime Level: Enter a pay rate overtime level.
Out On Service
Minimum Hours: Enter the minimum hours an employee will be given for going out in using
a function key setup to be Out On Service.
Accrue at Overtime: Y indicates the total time the employee is on service accrues to overtime.
Pay Overtime Level: Enter a pay rate overtime level.
In On Service Punch Negates The Previous: Y indicates if an employee returns to work after
leaving work, the given Out On service hours are eliminated.