AASTRA 6730i (Version 3.2) User Guide EN - Manual (Page 111)

Handling Calls
41-001376-00 Rev 01 – 06.2013
105
Reference
For more information on Centralized Conferencing, see “Centralized Conferencing” on page 157 or contact your System
Administrator.
Using Centralized Conferencing
Use the following procedure to create a conference call using centralized conferencing. Use the following illustration as a
reference.
Setting Up a Conference and Adding Multiple Parties (for Sylantro and Broadsoft Servers)
IP Phone UI
Note:
When Centralized Conferencing is enabled on your phone, local conferencing (or three-way conferencing) works as
indicated in the previous section,
“Using Local Conferencing in Pre-Dial Mode.” Joining two active calls in a conference
also works as indicated in the previous section, “Joining Two Active Calls in a Single Conference.”
Note:
You can have an unlimited number of parties in a conference (dependent on the limitations of the server.
1. When you begin a conference, you are the first party in the conference (Party 1). Pickup the handset or press the
Speakerphone Key.
A line opens up.
2. Call Party 2 by dialing their number (or answer an incoming call of a Party).
3. Wait for Party 2 to answer. When Party 2 answers, you can consult with them before adding them to Conference 1.
4. Press the Conf Key . A new line opens.
5. Enter the phone number of Party 3.
6. Wait for Party 3 to answer. When Party 3 answers, you can consult with them before adding them to the Conference 1.
Conference
Key
=Dial
2