Incomplete configuration, No service – AASTRA 6730i (Version 3.2) User Guide EN User Manual
Page 12
Getting Started
6
41-001376-00 Rev 01 – 06.2013
Incomplete Configuration
If your phone displays an "Incomplete Config" message without any extension or user name at the end of the start up
sequence instead of an Idle state screen, this indicates the phone configuration that was downloaded from the configu-
ration server is not complete or correct. Contact your System Administrator for assistance.
No Service
When the phone is not properly connected to the network, or the account has not been configured by the Network
Administrator, the "No Service" or "Network Disconnected" prompt appears on the display and the telephone status
light turns ON. The phone also displays the default time and date of 12:00am Jan. 1st, 2000. Check that the cables are
tightly connected to the phone and to the wall jack. The phone should automatically detect when the connection is
reconnected and display the "Network Connected" prompt temporarily.
If changes have been made to your phone settings, you may need to restart your phone. For more information on
restarting your phone, see
on
.
For more information about connecting your phone, refer to the Aastra 6730i Installation Guide. Check with your Sys-
tem Administrator for assistance.