AASTRA 6730i (Version 3.2) User Guide EN - Manual (Page 131)

Managing Calls
41-001376-00 Rev 01 – 06.2013
125
The following describes the behavior for each CFWD mode.
• Account - (default) The account mode allows you to configure CFWD on a per account basis. Pressing a configured
CFWD key applies to the account in focus.
• Phone - The Phone mode allows you to set the same CFWD configuration for all accounts (All, Busy, and/or No Answer).
When you configure the initial account, the phone applies the configuration to all other accounts. (In the Aastra Web UI,
only the account you configured is enabled. All other accounts are grayed out but set to the same configuration.) Using
the Aastra Web UI, if you make changes to that initial account, the changes apply to all accounts on the phone.
• Custom - The Custom mode allows you to configure CFWD for a specific account or all accounts. You can configure a
specific mode (All, Busy, and/or No Answer) for each account independently or all accounts. On the 6730i, you can set all
accounts to ALL On or ALL Off.
You can enable different CFWD rules/modes independently (for example, you can set different phone numbers for Busy,
All, and NoAns modes and then turn them on/off individually).
The following table describes the key and Message Waiting Indicator (MWI) LEDs when you enable CFWD on the IP Phone.
Note:
If there is only one account configured on the phone, then the mode setting is ignored and the phone behaves as if the
mode was set to “Phone”.
Key LED Behavior
for All Modes MWI LED Behavior
for All Modes
CFWD key LED RED if CFWD All, CFWD
Busy, or CFWD No Answer is enabled for
the account in focus.
CFWD key LED OFF if any CFWD mode is
disabled.
MWI LED ON if current account in focus has
CFWD ALL enabled.
MWI LED OFF if CFWD All is disabled.
Note:
If you make changes to the configuration for CFWD via the IP Phone UI, you must refresh the Aastra Web UI screen to
see the changes.