EVS IPDirector Version 6.0 - November 2012 Part 5 User's Manual - Manual (Page 65)

3. By moving the jog dial you can move through the list to highlight the required train.
4. Press Select Train again to select it and exit the menu.
The selected train is loaded on the player channel controlled by the ShuttlePRO.
How to Reload the Last Loaded Train or Recording
Ingest
If a clip is loaded on the Player pane, clicking the E/E button will unload it and load and
play the last loaded media (record train or recording ingest) at its current recording
position.
The text below the E/E button indicates the media (train or recording ingest) which the
channel will be loaded on the player channel when the E/E button is clicked:
Note
In case the previously recording ingest is finished when the E/E button is
clicked, the clip is loaded on its IN point and stays in pause. If this clip has been
deleted, nothing happens.
User Interface Button Keyboard Shortcut ShuttlePRO key
How to Load the Source Media of a Clip
The Ret button becomes active if a clip has been loaded in the Control Panel. By clicking
it, the same frame of media will be loaded from the original record train, if it is still available
(not overwritten in the recorder yet). This allows to play beyond the clip boundaries or to
define a new clip from the original record media.
IPDirector - Version 6.00 - User Manual - Control Panel
1. Control Panel 55