EVS IPDirector Version 6.0 - November 2012 Part 5 User's Manual - Manual (Page 67)

How to Snap back to the Last Loaded Train or
Recording Ingest
When a record train or a recording ingest is loaded on a player channel or on the Software
Player and then another media is loaded on that channel, the Snap function allows you to
go back to the previously loaded record train or recording ingest at the timecode where the
E/E mode was exited, effectively "snapping" back to where the user left off in the record
train or the recording ingest.
The difference with the E/E function is that the Snap function does not load the train at its
currently recording timecode.
User Interface Button Keyboard Shortcut ShuttlePRO key
+
1.4.3. Loading a Clip
How to Load a Clip or a Recording Ingest from the
Control Panel
To load a clip or a recording ingest on a player channel or the Software Player from the
Control Panel interface, proceed in one of the following ways:
• Enter the clip name in the Loaded Media field of the Control panel and press Enter.
• Enter the clip LSM ID in the LSM ID field and press Enter.
• Click the arrow next to the Last Created Clips field and select a clip from the list.
• When a clip has already been loaded during the current session, it is listed in the list
available from the Loaded Media field. Click the arrow next to the Loaded Media
field and select a clip from the list. This list contains the last 20 clips or trains that you
have loaded on the channel during the current session.
IPDirector - Version 6.00 - User Manual - Control Panel
1. Control Panel 57