Editing media, Introduction, How to trim a clip – EVS IPDirector Version 6.0 - November 2012 Part 5 User's Manual User Manual
Page 87
5. Click the OK button or press the ENTER key.
The playlist is created but it is empty. In case a player channel has been assigned to the
control panel, the playlist is created on-line. If the Software Player has been selected, the
playlist is created off-line.
See section "Adding Elements to a Playlist" on page 79 for the various ways to add
elements to a playlist.
1.7.
Editing Media
1.7.1.
Introduction
This section only provides procedures for some editing operations. Other simple editing
actions can be performed by selecting an option from the Control Panel contextual menu
or Playlist contextual menu. See sections "Control Panel Contextual Menu" on page 16
and "Playlist Contextual Menu" on page 33 for more details. See also
the Playlist Panel
user manual
.
1.7.2.
How to Trim a Clip
An existing clip can be trimmed and saved with the same name, so the updated clip
replaces the previous one. During this operation, the IN point and/or the OUT point of a
recorded clip can be modified and put within the [Protect IN – Protect OUT] duration of the
clip, i.e. clip duration including the guardbands.
To trim a clip, proceed as follows:
1. Load a clip on the Control Panel associated to a player.
2. Browse the clip to mark a new IN point and/or a new OUT point.
3. Click the IN button and/or the OUT button respectively, or use the corresponding
shortcuts.
4. Click the Update button to save the updated clip.
If the clip to trim is part of a group of linked clips, all the linked clips can be trimmed by
selecting the Trim all ganged clips setting under Tools > Settings > Clips > General.
Note
If the original record train is still available, clicking the Ret button will load the
media on the same frame than the loaded clip. This will allow retrieving media
outside the original clip boundaries.
IPDirector - Version 6.00 - User Manual - Control Panel
1. Control Panel
77