Fluke Networks CertiFiber Pro Users Manual - Manual (Page 177)

155
Chapter 7: How to Certify Fiber
Cabling

Warning

Before you use the tester, read the safety
information that starts on page 2.
Overview of the CertiFiber Pro Optical Loss
Test Set Modules
The Fluke Networks CertiFiber ® Pro Optical Loss Test Set (OLTS)
modules attach to Versiv ™ main and remote units to make
rugged, hand-held testers that let you certify, troubleshoot, and
document optical fiber cabling installations. The testers include
these features:
 Measures optical power loss and length on dual-fiber,
multimode cabling at 850 nm and 1300 nm (CFP-MM) or on
dual-fiber singlemode cabling at 1310 nm and 1550 nm
(CFP-SM). The four-wavelength module (CFP-QUAD) measures
at 850 nm, 1300 nm, 1310 nm, and 1550 nm.
 Interchangeable connector adapters on input and output
ports let you make reference and test connections that agree
with ISO standards for most SFF (small form factor)
connectors.
 Visual fault locator helps you find breaks, bad splices, and
bends and verify fiber continuity and polarity.
 You can save approximately 30,000 loss/length fiber test
results in the tester’s internal memory. You can save more
results on a removable flash drive.