Fluke Networks CertiFiber Pro Users Manual - Manual (Page 336)

Versiv Cabling Certification Product Family
Technical Reference Handbook
314
3-7. On the TEST SETUP screen, make sure the Test Type shows
Smart Remote. If it does not, tap Test Type, then tap Smart
Remote.
3-8. On the TEST SETUP screen, select and change the test settings
as necessary for the loss/length test.
For this tutorial, set Bi-Directional to Off.
For information about other loss/length test settings, see
“Settings for Loss/Length Tests on Fiber” on page 170.
3-9. When you have completed your selections for the Smart
Remote test, tap SAVE on the TEST SETUP screen.
To set up an OTDR test for the project
3-10. On the PROJECT screen, tap NEW TEST.
3-11. If the TEST SETUP screen does not show an OptiFiber Pro
module, tap Module.
If a module is not attached, the MODULE screen shows.
On the MODULE screen, tap an OptiFiber Pro OTDR module.
3-12. On the TEST SETUP screen, make sure the Test Type shows
Auto OTDR. If it does not, tap Test Type, then tap Auto OTDR.
3-13. On the TEST SETUP screen, select and change the test settings
as necessary for the Auto OTDR test. For information about
OTDR test settings, see “Settings for OTDR Tests” on page 222.
For this tutorial, set Launch Compensation to Off.
3-14. When you have completed your selections for the Auto OTDR
test, tap SAVE on the TEST SETUP screen.