Fluke Networks CertiFiber Pro Users Manual - Manual (Page 367)

345
Chapter 15: Custom Media and Test
Limits
How to Make a Custom Twisted Pair Cable
Type
If a twisted pair cable installation has a cable type that is not in
the list of types in the tester, you can make a custom cable type
for the job. A custom twisted pair cable type has these settings:
 Custom cable name
 Standard cable type used for default values
 NVP (nominal velocity of propagation)
You can make up to 20 custom cable types. The tester keeps
custom cable types with the other cable types in the main Versiv
unit (not in the module). The names of custom cable types have
an asterisk (*) at the start and end.
Use the values specified by the cable manufacturer to make the
custom cable type.
To make a custom cable type
1 On the home screen, tap the test setup panel.
2 On the CHANGE TEST screen, tap a copper test, then tap EDIT.
Note
You must select a test before you make a custom
cable type, but you can use the cable type in any
test that supports the category of the cable.
3 On the TEST SETUP screen, tap Cable Type, tap MORE, tap
Custom, then tap MANAGE.
-continued-