Fluke Networks CertiFiber Pro Users Manual - Manual (Page 87)

Chapter 3: How to Certify Twisted Pair Cabling
The Home Screen for DSX CableAnalyzer
65
 Shows a summary of the test results in the project:
The number of tests that passed.
The number of tests that failed.
The number of results from tests on twisted pair cable that
have measurements within the range of accuracy uncertainty for
the tester. See “PASS*/FAIL* Results” on page 79.
 The test setup panel shows the settings the tester will use when
you tap TEST or press . To change these settings, tap the
panel.
Note
You can set up tests for any module that the
tester can use, even when no module is attached.
 Icons show the status of the Store Plot Data and AC Wire Map
settings. See Table 2 on page 72.
 Next ID: The Next ID panel shows the ID that the tester gives to
the next test results you save.
Tap Next ID to do these tasks:
 Enter an ID, select a different ID in the ID set, select a
different set of IDs, or make a new set. The tester adds the
IDs and ID sets you make to the project that shows on the
home screen.
 Turn Auto Save on or off.
 Operator: The name of the person who does the job. You can
enter a maximum of 20 operator names.
 TOOLS: The TOOLS menu lets you set the reference, see the
status of the tester, and set user preferences such as the
language and the display brightness.
 RESULTS: Tap RESULTS to see and manage the results that are
saved in the tester.
 TEST: Tap TEST to do the test shown in the test setup panel.