Fluke Networks CertiFiber Pro Users Manual - Manual (Page 402)

Versiv Cabling Certification Product Family
Technical Reference Handbook
380
CertiFiber Pro OLTS Loss/Length Specifications
Specification
CertiFiber Pro
Multimode Modules
CertiFiber Pro
Singlemode Modules
Testing speeds
(excluding
referencing
times) Smart Remote mode (2 wavelengths, one direction):  3 s
Far End Source mode
1 (2 wavelengths, one direction): 2 s
Loopback mode (2 wavelengths, one direction):  2 s
Input/output
connectors Interchangeable connector adapter (LC standard on input,
SC standard on output)
Launch
Condition Encircled flux compliant to TIA 455-526-14-B, 
ISO/IEC 14763-3, and IEC 61280-4-1
2,3
Fiber types
tested 50/125 µm, 62.5/125 µm
multimode fiber Singlemode fiber
Source type and
wavelengths Multimode LED source
850 nm  30 nm
1300 nm  20 nm Fabry-Perot laser diode
1310 nm  20 nm
1550 nm  30 nm
Maximum
length
measurement 12 km 130 km
Length
measurement
accuracy  1.5 m plus  1 % of length
Output power
(nominal)  -24 dBm with EF-TRC  -4 dBm
Output power
stability
4
 0.05 dB over 8 hours
 0.03 dB over 15 minutes  0.1 dB over 8 hours
 0.08 dB over 15 minutes
1. In Auto CertiFiber Pro mode. In Auto SimpliFiber Pro mode: < 4 seconds (2
wavelengths). With the source in continuous-wave mode: < 1 second (1
wavelength).
2. At the output of the EF-TRC.
3. Variations between EF measurement equipment may occur but EF compliance can
be expected with a 95 % confidence factor.
4. At constant temperature, relative to power level after 15 minute warm up.