Fluke Networks CertiFiber Pro Users Manual - Manual (Page 237)

Chapter 8: The Power Meter and Light Source
How to Control the Light Source
215
GPU127.EPS
Figure 94. Light Source Controls for the Main Tester
 Use the buttons to control the output port when you use the
main tester as a light source:
 Auto: In this mode, the output port transmits both
wavelengths. The signal includes identifiers that tell a
CertiFiber Pro or SimpliFiber Pro power meter when to
measure power at each wavelength. Use this mode only
with a CertiFiber Pro or SimpliFiber Pro power meter.
 Off: The output port does not transmit the selected
wavelength.
 CW: The output port transmits a continuous signal at one
wavelength. Use this mode if the power meter is not a
CertiFiber Pro or SimpliFiber Pro meter.
 The laser icon is red when the output port transmits the
wavelength adjacent to the icon.
 When the tester has a CertiFiber Pro Quad module installed, use
this control to select multimode or singlemode wavelengths
A
C
B