Grain Systems PNEG-1708 - Manual (Page 43)

8. Assembling Ladders, Platforms and Catwalks
PNEG-1708 GSI Modular Tower Dryer 43
11. After attaching the catwalk brace to the catwalk brackets on the dryer wall, attach a catwalk transition
to the top of each catwalk brace. (See Figure 8X.)
IMPORTANT: Note the hole alignment on the catwalk transition. The “five (5) hole” pattern near the
center of the transition MUST be oriented so that the center hole is AWAY from the
dryer wall.
(See Figure 8W and Figure 8X.)
Figure 8W
NOTE: Transition must line up on catwalk brace slot to slot. The SLOT indicated in the Figure 8W
must be oriented away from the dryer wall. Do NOT fill the middle hole of the transition.
Figure 8X
Dryer
Align this SLOT away from dryer
and to HOLE in catwalk transition
Catwalk transition
No bolt used here
Catwalk transition
Dryer
No bolt used here